Difference between revisions of "How to configure and use CAN bus"
m (moved Enabling Can Bus to Enabling CAN Bus) |
|||
Line 3: | Line 3: | ||
== Build the SDK with socketcan and ip tools == | == Build the SDK with socketcan and ip tools == | ||
Working with the CAN buys requires enabling the 'ip' tools from iputils2 package (the 'ip' tool from busybox won't work). The socketcan package is optional and provide you with tools to debug your can bus. | Working with the CAN buys requires enabling the 'ip' tools from iputils2 package (the 'ip' tool from busybox won't work). The socketcan package is optional and provide you with tools to debug your can bus. | ||
+ | |||
+ | This packages are available from the RidgeRun SDK in the configuration menu. | ||
== Enable the kernel driver == | == Enable the kernel driver == |
Revision as of 05:05, 31 May 2010
This article explains how to enable the CAN bus using as example the AM35x EVM, but can be applied to other platforms as well.
Contents
Build the SDK with socketcan and ip tools
Working with the CAN buys requires enabling the 'ip' tools from iputils2 package (the 'ip' tool from busybox won't work). The socketcan package is optional and provide you with tools to debug your can bus.
This packages are available from the RidgeRun SDK in the configuration menu.
Enable the kernel driver
In the case of the Category:AM35x platform the configuration is:
Linux Kernel Configuration Networking support CAN bus subsystem support CAN device drivers Platform CAN drivers with Netlink support CAN bit-timing calculation TI High End CAN controller (HECC)
Setup the networking rules
Edit your /etc/networking/interfaces on the target filesystem and add the following rules (required to setup the bit-rate of the bus: