NVIDIA Jetson Orin - Connect Tech Forge

NVIDIA®Jetson AGX Orin™
Introduction
SoM Overview Carrier Boards NVIDIA developer kit Auvidea X230D Connect Tech Forge Software Development Support
JetPack 5.0.2
Getting Started Installing JetPack Flashing the board with GUI installer JetPack Components Compiling Source Code Flashing the Board from Cmdline Performance Tuning Evaluating Performance Set Values Manually Tuning Power Maximizing Performance Software Encoders For Jetson Orin Nano
Development in the Board
Getting into the Board Using Serial Console Using SSH Using Ubuntu Login Installing Packages
Emulation
Flashing commands for emulation
Supported Cameras
IMX477+J20 Driver
GStreamer Pipelines
Capture and Display H264 H265
RidgeRun Products
GstPTZR GstCUDA GstColorTransfer GstWebRTC GstRtspSink GstInterpipe GstInference GstVPI GStreamer Daemon GstShark
RidgeRun Reference Designs
Panoramic Stitching and WebRTC Streaming
Reference Documentation
Contact Us

Forge is Connect Tech’s first full-featured Carrier Board for the NVIDIA® Jetson AGX Orin™ module. This carrier board for Jetson AGX Orin™ is specifically designed for commercially deployable platforms and has a small footprint of 155mm x 125mm.

Forge provides access to an impressive list of latest-generation interfaces on the Jetson AGX Orin while adding additional interfaces of 3x USB 3.2, 2x GbE, Display Port, and a locking 6-pin Mini-Fit Jr. power input connector.

Rugged camera add-on expansion boards will also be available for use with Forge to interface directly with high-density MIPI CSI interfaces. Figure 1 shows a picture of the Forge carrier board and Table 1 shows its specifications.

Figure 1: Top view of Forge Carrier for NVIDIA® Jetson AGX Orin™

Table 1: Connect Tech's Forge Carrier Board Specification

Feature	Description
Networking	2x 10GBASE-T (10G Ethernet) 2x 1000BASE-T (1G Ethernet)
Camera Inputs	1x DisplayPort
Display	1x 16-Lane MIPI Expansion Connector Interface directly to a range of MIPI CSI, GMSL2 or FPD-Link III image sensors.
USB	1x USB 3.2 Ports (Type-C – OTG Capable), 1x USB 3.2 Ports (Type-C)
Storage	1 x Micro SD/UFS Card Slot, 2x NVMe M.2 Key M Slot
UART	2x @ 3.3V levels UART1 and UART2 2x RS-232/485 UARTs
I2C/SPI	2x I2C Channel @ 3.3V IO 2x SPI Channel @ 3.3V IO
GPIO	4x GPI, 4x GPO
User Expansion	1x M.2 Key E 2230 Wifi/BT (PCIe/USB2) 1x M.2 Key B 3042/3052 (LTE/5G – USB3) with Micro SIM
Input Power	+10 to 36V DC Wide Input Power (6-pin Mini-fit Jr. Connector)
Buttons	Power, Reset, Recovery (Tactile Buttons as well as fine pitch pin header connector)
RTC Battery	3-pin Picoblade connector to accept CTI battery cable assembly
PCB/Electronics Mechanical Information	Dimensions: 155mm x 125mm
Operating Temperature	-40°C to +85°C (-40°F to +185°F)

You can get this board from the Forge Product Page