Qualcomm Robotics RB5/RB6 - Update Ubuntu Packages

Qualcomm Robotics RB5/RB6
Introduction
SoM Overview Carrier Boards Qualcomm Robotics RB5 developer kit Qualcomm Robotics RB6 platform
Software Development Support
Boot Devices Thundercomm SDK Downloading SDK Installing SDK Generating Image and flashing Linaro Getting Started Flashing Bootloader Flashing Boot Image and Rootfs Special / Debug Modes Setting up board in EDL Mode Setting up board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup WiFi setup HDMI setup Update Ubuntu Packages
Build from source
Base Image Customize Image
Capture Subsystem
Hardware Capture Components Software Capture Components Building your own camera sensor driver
Image Processing and Acceleration Software
GPU Profiling Fast CV Installing Hexagon SDK Installing Fast CV Building your own Fast CV application
GStreamer Pipelines
Capture and Display Video Encoding Video Decoding
AI Acceleration
Neural Processing SDK Downloading Requirements Setup SDK Environment Install qtimlesnpe Example Project TensorFlow Example pipeline
Contact Us

This section will help you to update the Ubuntu packages once you have internet access on the board, see the section WiFi Setup. You will need to access the board with ADB, if you haven't installed ADB in your host PC, follow the step 2 in the section Linaro-Getting Started, and if you want to know how to connect to the board with ADB, read the section Using ADB skipping step 4, before continuing.

1. In your host PC, type the following command to access the board:

adb shell

Your terminal should change and look similar to the following:

#

2. Type the following commands to update Ubuntu packages:

# apt-get update