Qualcomm Robotics RB5/RB6 - Setting up board in EDL Mode

Qualcomm Robotics RB5/RB6
Introduction
SoM Overview Carrier Boards Qualcomm Robotics RB5 developer kit Qualcomm Robotics RB6 platform
Software Development Support
Boot Devices Thundercomm SDK Downloading SDK Installing SDK Generating Image and flashing Linaro Getting Started Flashing Bootloader Flashing Boot Image and Rootfs Special / Debug Modes Setting up board in EDL Mode Setting up board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup WiFi setup HDMI setup Update Ubuntu Packages
Build from source
Base Image Customize Image
Capture Subsystem
Hardware Capture Components Software Capture Components Building your own camera sensor driver
Image Processing and Acceleration Software
GPU Profiling Fast CV Installing Hexagon SDK Installing Fast CV Building your own Fast CV application
GStreamer Pipelines
Capture and Display Video Encoding Video Decoding
AI Acceleration
Neural Processing SDK Downloading Requirements Setup SDK Environment Install qtimlesnpe Example Project TensorFlow Example pipeline
Contact Us

Connecting the board in USB flashing mode (aka EDL mode)

In this section we will explain the steps on how to setup the board in the EDL Mode. EDL Mode is used for recovering/flashing the board over USB.

Error creating thumbnail: Unable to save thumbnail to destination

WARNING

Putting the device into EDL mode while it is powered or when USB is plugged in can cause damage to the board.

Note

Please read every step before starting.

1. Power off the board and unplug the USB type-C cable.

2. Set the switch DIP_SW_0 to “0 1 1 0 0 0”, please check figure 1 and 2. This configuration means that the board debug UART is enabled and that the board will power on automatically when main power is asserted.

Error creating thumbnail: Unable to save thumbnail to destination Figure 1: DIP Switch 0.

Error creating thumbnail: Unable to save thumbnail to destination Figure 1: DIP Switch 0 set to "0 1 1 0 0 0".

3. Press button 18, it is marked with "F_DL". This button is located on the back of the board. Please check figure 3 and 4.

Error creating thumbnail: Unable to save thumbnail to destination Figure 3: F_DL Button from side view.

Error creating thumbnail: Unable to save thumbnail to destination Figure 4: F_DL Button from bottom view.

4. While pressing the F_DL button, power on the device with the proper power supply. Do NOT stop pressing the button.

5. While pressing the F_DL button, plug in the USB type-C cable between the board and the host computer. Stop pressing the F_DL button.

6. To check if everything went well, you can check the USB connections with dmesg.

dmesg | grep usb

It will show something like:

[281089.835630] usb 2-1: Qualcomm USB modem converter now attached to ttyUSB0