Qualcomm Robotics RB5/RB6 - Setting up board in Fastboot Mode

Qualcomm Robotics RB5/RB6
Introduction
SoM Overview Carrier Boards Qualcomm Robotics RB5 developer kit Qualcomm Robotics RB6 platform
Software Development Support
Boot Devices Thundercomm SDK Downloading SDK Installing SDK Generating Image and flashing Linaro Getting Started Flashing Bootloader Flashing Boot Image and Rootfs Special / Debug Modes Setting up board in EDL Mode Setting up board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup WiFi setup HDMI setup Update Ubuntu Packages
Build from source
Base Image Customize Image
Capture Subsystem
Hardware Capture Components Software Capture Components Building your own camera sensor driver
Image Processing and Acceleration Software
GPU Profiling Fast CV Installing Hexagon SDK Installing Fast CV Building your own Fast CV application
GStreamer Pipelines
Capture and Display Video Encoding Video Decoding
AI Acceleration
Neural Processing SDK Downloading Requirements Setup SDK Environment Install qtimlesnpe Example Project TensorFlow Example pipeline
Contact Us

Fastboot mode

In this section we will cover how to set up your board for it to be ready to be flashed. For this, we will show the steps to boot your RB5/RB6 into fastboot mode.

1. With the board powered off (unplugged from power), set the BOOT_CONFIG DIP Switch in the board to '0-0-0-0'; in other words, every switch should be in "OFF" position. Please check Figure 1 for reference on how to configure the DIP SWITCH.

Error creating thumbnail: Unable to save thumbnail to destination Figure 1: Buttons and DIP switches of Qualcomm Robotics RB5.

Error creating thumbnail: Unable to save thumbnail to destination Figure 1: BOOT_CONFIG DIP Switch 0-0-0-0 position.

2. Boot RB5/RB6 into fastboot mode.

Note

Please read every step before starting.

• Disconnect the power cable from the board and check no USB cable is connected either.
• Hold down the "VOL-" button while connecting the power supply.
• Tap the "ON/OFF" button while continuing to hold the "VOL-" button, at least 5 seconds after plugging the power cable.
• Release "VOL-" button.
• Connect the USB3 Type C cable between the host PC and the RB5/RB6 board.

3. Check if the board is connected and in fastboot mode by opening a terminal in the host computer and running the following command:

user@desktop:~/work/QRB5_Exploration/Linaro$ sudo fastboot devices 
3b73cc0	fastboot

You can also check the USB connections with dmesg, using the following command:

user@desktop:~/work/QRB5_Exploration/Linaro$ dmesg | grep -i usb
[281714.226579] usb 2-1: Product: Android
[281714.226582] usb 2-1: Manufacturer: Google
[281714.226585] usb 2-1: SerialNumber: 3b73cc0

4. At this point, you should be ready to flash your board.