Qualcomm Robotics RB5 - Software Support - Debug modes

Qualcomm Robotics RB5/RB6
Introduction
SoM Overview Carrier Boards Qualcomm Robotics RB5 developer kit Qualcomm Robotics RB6 platform
Software Development Support
Boot Devices Thundercomm SDK Downloading SDK Installing SDK Generating Image and flashing Linaro Getting Started Flashing Bootloader Flashing Boot Image and Rootfs Special / Debug Modes Setting up board in EDL Mode Setting up board in Fastboot Mode
Development in the Board
Getting into the Board Using ADB Using Serial Console Using SSH Device Setup WiFi setup HDMI setup Update Ubuntu Packages
Build from source
Base Image Customize Image
Capture Subsystem
Hardware Capture Components Software Capture Components Building your own camera sensor driver
Image Processing and Acceleration Software
GPU Profiling Fast CV Installing Hexagon SDK Installing Fast CV Building your own Fast CV application
GStreamer Pipelines
Capture and Display Video Encoding Video Decoding
AI Acceleration
Neural Processing SDK Downloading Requirements Setup SDK Environment Install qtimlesnpe Example Project TensorFlow Example pipeline
Contact Us

The Qualcomm Robotics RB5/RB6 has two modes that allow recovery of the board and to flash it. The following sections will show you the process on how to setup your board in these modes if needed.

• The EDL Mode section is a guide to setup your board in EDL Mode.
• The Fastboot Mode section is a guide to setup your board in Fastboot Mode.