IMX8/Nitrogen8M/Getting Started/Selecting Boot Options

i.MX8
Introduction
SoC Overview Carrier Boards i.MX6 vs i.MX8
iMX8M Evaluation Kit (EVK)
Overview Getting Started Selecting Boot Mode System Setup Software Support Android_SD_Partitions_RidgeRun_Script Loading pre-built images Yocto Support Building Yocto Installing an Image Alternative image loading Android Support Building Android Installing an Image System Recovery
Nitrogen8M
Overview Getting Started Selecting Boot Mode System Setup Software Support Loading pre-built images Yocto Support Building Yocto Installing an Image Alternative image loading Customizing Boot Sequence Android Support Building Android Installing an image System Recovery
Multimedia
GPU OpenGL OpenCL OpenVX OpenVG Vulkan VPU Encoding System Decoding System ISP Support V4L2 Drivers Porting Guide GStreamer Support Package Installation Pipeline Examples Hardware-accelerated plugins RidgeRun Products GstRtspSink GstWebRTC GstPTZR GstQtOverlay
Reference Documentation
Contact Us

Boot Loading Options

The Nitrogen8M provides a switch in order to set the boot configurations according to your needs. You can see the switch on the following picture:

IMAGE

This switch allows to configure the boot source by selecting one of the following options:

• Serial Downloader: The Nitrogen8M downloads a program image from a USB connection.
• Internal Boot: The boot mode is selected according to U-Boot, the variable boot_targets controls boot device (EMMC or SDCARD).

In the following table you can see how to configure each boot mode.

Boot Source	PIN
Serial Downloader	ON
Internal Boot	OFF

The bootable source code is selected from the switch and U-Boot, the complete information is presented in the following table:

BOOT Source	PIN	boot_targets
Serial Downloader	ON	---
Boot from EMMC	OFF	mmc0
Boot from USB	OFF	usb0

BOOT Switch Configuration for EMMC and USB

This is how the physical switch should be set in order to boot from EMMC or USB:

EMMC

The EMMC device is the default boot device chosen by U-Boot, this memory is preloaded with Android 8.1.

USB Boot

This Boot option also requires a Bootable USB stick and a Serial Console Cable.

Instructions to setting up the USB Boot from U-Boot:

• Connect the Nitrogen8M to a host machine with the Serial Console Cable.
• Start any serial console (i.e minicom or term).
• Power on the board, the console will display the U-boot start-up screen.
• Press any key on your keyboard to stop the boot sequence, this will display the U-Boot console.
• Change the Boot Device with the following command:

setenv boot_targets usb0

• If you do not want to repeat this process, you can save the selected Boot Device with this command:

saveenv

• Continue the Boot sequence by typing the next command:

boot

After the previous instructions, the board will boot from the USB stick

Advanced Boot Options

You can load the kernel and filesystem by using advanced methods. Please refer the Advanced Boot Options page for more information.