i.MX8 - i.MX8M EVK System Setup

i.MX8
Introduction
SoC Overview Carrier Boards i.MX6 vs i.MX8
iMX8M Evaluation Kit (EVK)
Overview Getting Started Selecting Boot Mode System Setup Software Support Android_SD_Partitions_RidgeRun_Script Loading pre-built images Yocto Support Building Yocto Installing an Image Alternative image loading Android Support Building Android Installing an Image System Recovery
Nitrogen8M
Overview Getting Started Selecting Boot Mode System Setup Software Support Loading pre-built images Yocto Support Building Yocto Installing an Image Alternative image loading Customizing Boot Sequence Android Support Building Android Installing an image System Recovery
Multimedia
GPU OpenGL OpenCL OpenVX OpenVG Vulkan VPU Encoding System Decoding System ISP Support V4L2 Drivers Porting Guide GStreamer Support Package Installation Pipeline Examples Hardware-accelerated plugins RidgeRun Products GstRtspSink GstWebRTC GstPTZR GstQtOverlay
Reference Documentation
Contact Us

Setup serial console communication

Follow the next instructions to establish a serial communication with the board:

1. Shipped with the i.MX8 EVK is a USB Debug Cable. Plug the micro-B end of that USB cable to the EVK debug UART port J1701, as shown in the picture:

Serial cable attached to i.MX8M EVK

2. Attach the other end of the USB cable to your computer.

And you are ready with the required console physical connection. Now you can use your favorite terminal application to access the board. If you are not familiar with any terminal application, for Linux you can use minicom or picocom, please try one of the following instructions:

• Setting up Minicom
• Setting up Picocom